Will Bleach Hurt Colored Concrete?

Will Bleach Hurt Colored Concrete?

Yes, bleach will hurt coloured concrete. If you have decorative colored concrete in your home, you know it can be challenging to keep it looking its best.

Unfortunately, regular cleaners aren’t always effective at removing stains, which can lead to faded colors and a loss of the sealant that protects the concrete from weathering and damage.

You must use a gentle cleaner specifically designed for decorative concrete to get the most out of your concrete.

If your decorative colored concrete is looking a little tarnished, it might be time for a restoration. But before you reach for the bleach, remember that this flooring is not your average garage floor.

You can’t use the typical ammonia-bleach- and acid-based cleaners recommended for concrete — they’ll ruin the concrete’s sealant and colouring.

Can Concrete Be Colored After It Is Poured?

Yes, this is an option, but you should be cautioned to avoid over-applying the colourant.

Once the concrete is poured, it tends to absorb any additional colours you add, which can alter its appearance over time.

It’s usually a good idea to try and limit the amount of colour you add or apply it in smaller quantities instead of one large pour. Plans do exist for pouring coloured concrete into molds, so check with your local concrete supplier for advice on this option.

A color hardener applied to the top layer of concrete after it has been poured is another technique for colouring concrete.

While using a color hardener produces more bright colors than adding colorant to the mix, any dents or edges in the completed slab will be visible because the color is just on the surface of the concrete.

Is Colored Concrete Slippery?

Yes, coloured concrete can be slippery. Coloured concrete is made from a special material that has a much higher lime content than regular concrete, which makes it prone to problems with slipping and sliding when wet.

Coloured concrete is most prone to problems when wet because the more lime in the mix and the higher its water content, the more likely it is to be slippery.

Some people might think stained concrete is not as slippery as other hard, smooth surfaces, but that’s not always the case. When concrete is wet, it can be quite slippery. This is especially true if the concrete has been coated with a high-gloss sealer.

Fortunately, there are ways to increase the slip resistance of stained concrete without affecting its color. One way is to seal the concrete with a water-repelling sealant. Another is to use a rubberized surface treatment.

Either of these methods will make the concrete less slippery when wet, which is important in areas that are exposed to moisture or in areas frequented by many people.