How Do You Cover A Leaking Roof With A Tarp?

How Do You Cover A Leaking Roof With A Tarp?

You must act quickly and come up with a way to stop water from entering your property when a leak first appears.

Tarping is a terrific technique to achieve this and serves as a decent stopgap measure until a roofing specialist can visit your house to perform the necessary repairs. In this case, by following these instructions, tarp your roof for the time being.

1. Compile the necessary supplies for the job.

Ensure you have all the items needed for this project before starting. Have a ladder, broom or brush, knife, cordless drill, 2×4 wooden boards, 3 14 nails, and a saw available before you start.

Of course, you’ll also need a tarp, which should be large enough to stretch at least three feet beyond the perimeter of the damaged area.

Tarps with UV inhibitors perform even better and tend to last longer while you wait for repairs to be completed. All of these materials are available at your neighborhood hardware shop.

2. Fill up Holes.

You may often skip this step, but if you detect gaps in your roof’s plywood, they should be covered. Obtain plywood and cover the space, fixing the outermost section with screws every 6 to 12 inches.

3. Remove Clutter.

Roof damage is commonly caused by adverse weather and storms, particularly in Florida. If this is the case, remove any debris in your path. Before putting up your tarp, carefully brush this stuff off the roof. Avoid slipping and moving heavy garbage on your own.

4. Position the Tarp.

Unfold or roll your tarp to cover the damaged area over the roof’s peaks and eaves, ensuring that at least a foot of tarp is left on each side.

Be cautious if it’s windy since the tarp may try to fly away. Place your wood boards around the perimeter to keep them from moving as you secure them. Remember, never walk on the tarp since it is slippery.

To fix the wood, roll the tarp’s edges with 2×4’s and nail it to the tarp with 3 ¼ inch nails. Following this, sandwich the tarp between two more 2×4 and temporarily fasten the lower 2×4 to the roof with a nail.

5. Attach Your Roof with the Tarp.

Finally, tie the tarp so that no water can get in; after all, that’s why you’re here in the first place! Screw through the rolled 2x4s with your screw gun, ensuring the screws reach the ceiling.

Secure any remaining loose edges with extra 2x4s – they do not need to be rolled but should be attached to the tarp. To keep your home dry and debris-free, fasten all sides of your tarp.