What Is Dead Load In Construction? Dead loads are the weight of a building or structure’s fixed components, such as its beams, walls, and roof. They are also known as permanent or static loads, as they remain relatively constant over time. Dead loads may include non-structural elements like built-in cabinets and immovable fixtures. Calculating dead […]
Advantages and Disadvantages of Orifice Meter | Uses of Orifice Plate | Venturi vs Orifice Meter | Applications And Uses of Orifice Meter What is Orifice? Orifice Plate & Meter An orifice plate is a device that is used to measure flow rate, reduce pressure, or restrict flow. It is a type of flow meter […]
What is a Venturi Meter? | Venturi Meter Advantages and Disadvantages | Venturi Effects | Types of Venturi Meters? What is a Venturi Meter? A venturi meter is a device that measures the flow of fluid through pipes. The idea of Bernoulli’s equation underpins this flow measurement device. Pressure differential is established inside the pipe by […]
What is Hydrostatic Pressure? |Hydrostatic Pressure in Concrete | Causes Hydrostatic Pressure in Foundations |Drilling Holes to Relieve Hydrostatic Pressure |Weep Holes in Retaining Wall What is Hydrostatic Pressure? Hydrostatic pressure is the force that pushes water, and other fluids, out of their containers. When a column of liquid is forced up from its container […]
What is Angle of Loll? Angle of List | What is Waterline | Definitions and Use of Block Coefficient Angle of Loll The situation of a ship that is unstable when upright (i.e., has a negative metacentric height) and so takes on an angle of heel to either port or starboard is referred to as […]
Definition and Application of Metacentric Height | Metacentric Height Calculation Formula | What is Buoyant Force | What is Centre of Buoyancy What is Metacentric Height? The metacentric height is a measure of a floating body’s initial static stability. It is calculated as the distance between a ship’s center of gravity and its metacentre. Greater […]
Hogging and Sagging | Difference Between Sagging and Hogging Bending Moments | Causes Sagging and Hogging Bending Moments In Ship | Negative and Positive Bending Moments What is Hogging and Sagging? Hogging and sagging are terms used in solid mechanics, structural engineering, and shipbuilding to describe the shape that a beam or similar long item […]
What is Castigliano’s Theorem? Castigliano’s First & Second Theorem Applications , Advantages What is Castigliano’s Theorem? Castigliano’s theorem, named after Carlo Alberto Castigliano, is a method for calculating the displacements of a linear-elastic system using partial derivatives of energy. He is well-known for two theorems. Castigliano’s First Theorem The first partial derivative of the total […]
What Does Wing Wall Mean In Construction? A wing wall (also known as a “wing wall” or “wing-wall”) is a smaller wall attached to or adjacent to a larger wall or structure. Wing walls are commonly used in bridge construction and act as a retaining wall to contain backfill material behind the abutment wall and […]
What Is An Elastic Modulus? The Elastic modulus is a measure of a material’s stiffness or rigidity. It is defined as the ratio of stress to strain below the proportional limit. The modulus of elasticity is the slope of the stress-strain curve in the range of linear proportionality of stress to strain. The greater the […]